Update E steps config after calibration, update readme

README.md

@@ -110,13 +110,14 @@ Thermal probes in use:
 - Setup filament sensor
 - Add printing tracking camera 
 
-- All macros are untested until stated otherwise, list of tested macros: 
+- All macros are untested until stated otherwise (cloned from duet repos), list of tested macros: 
 - - Lighting (all)
 - - Preheat (all)
 - - PID tuning Bed && HotEnd
 - - Preheat PLA / ASA / PETG
 - - Musical Tunes
 - - Diagnostics/Disallow unhomed moves
+- - Diagnostics/E steps calibration
 
 ## Electronics backplate
 I've also set a exectronics backplate (to be a cut of alluminium or polycarbonate up to 4mm), you may find it in [thingiverse.com](https://www.thingiverse.com/thing:4792093).

config.g

@@ -18,7 +18,7 @@ M569 P0.5 S0 D3 H50 V50                        ; physical drive 0.5 goes backwar
 M584 X0.3 Y0.4 Z0.0:0.1:0.2 E0.5               ; set drive mapping
 M350 X16 Y16 Z16 E16 I1                        ; configure microstepping with interpolation
 
-M92 X160.00 Y160.00 Z1600.00 E873.08               ; set steps per mm
+M92 X160.00 Y160.00 Z1600.00 E794.43               ; set steps per mm
 M566 X400.00 Y400.00 Z6.00 E120.00                 ; set maximum instantaneous speed changes (mm/min)
 M203 X10800.00 Y10800.00 Z1000.00 E1600.00         ; set maximum speeds (mm/min)
 M201 X3000.00 Y3000.00 Z100.00 E3600.00            ; set accelerations (mm/s^2)